Occasionally, a lot of soil residues are not cleaned up in the automatic concrete mixer, so there are many accidents in the operation process. The editor told you that this method can easily clean up the residue of the automatic concrete mixer, go and have a look!
First, prepare the emergency drive hose, turn off the machine, and remove the high-pressure oil pipe connector on the hydraulic motor.
Turn off the rescue vehicle, remove the high-pressure oil pipe of the hydraulic motor, and connect it with the corresponding connector on the faulty vehicle using the emergency drive hose.
Start the rescue vehicle and move the operating handle to the discharging position, and the mixture in the faulty vehicle will be discharged.
When the emergency drive is completed, remove the drive hose in the fully automatic concrete mixer and restore it to its original state.
Put a wooden wedge between the tugboat and the raceway, control the rotation of the mixing drum, turn off the engine, remove a high-pressure oil pipe of the hydraulic motor, and the mixing drum can rotate freely and control the rotation of the mixing drum. So that the maintenance hole can be turned to the lower position, and then the maintenance hole can be opened, and the concrete in the cylinder can be cleaned. When the concrete is discharged, the original state of the fully automatic concrete mixer can be restored.
The above methods can remove the residual soil residue. No matter which method you use, you should pay attention to the safety. Come to our website for more relevant matters http://www.zkzdsljbc.com Ask about it!