No matter what kind of mechanical equipment will pay attention to the operation of things, small concrete mixer is of course no exception, here it is recommended to drive slowly, so that the safety will be guaranteed. Let's talk about that.
Take it slow when you turn corners. The small concrete mixer has a high center of gravity and is prone to accidents when driving at high speed. Slow down before entering a corner, and try not to brake when turning. Pay attention to observe whether the stirring tank is turning at any time, and adjust the speed as slow as possible. If the speed is too high, the vehicle will swing and roll over. The mixer needs to stop the tank on the road with a large tilt Angle. When fully loaded, go to the section with a large tilt Angle and stop the rotation of the tank can make the vehicle run more smoothly.
When turning, pay attention to the operation of the brake: under the direction of the brake, the concrete mixing car is easy to lose the center of gravity, so before entering the bend should fully reduce the speed through the brake. But if it's too late to slow down, use the brakes briefly, depending on the situation. Wet curve road emergency braking is prone to tail rejection, can reduce the wave box gear, using engine braking to slow down.
Please pass the bad road at low speed. Encounter uneven road surface, potholes with the appropriate low speed block through, to ensure that the car has explosive power at any time. Avoid clutter. Advance gear reduction on uphill. Start to smooth, can not be disorderly, reduce gear in advance, to maintain sufficient power of the vehicle. Pay attention to the height limit. Before transportation, plan the route and pay attention to the height limit. The road conditions at the site are complicated. Be careful of trees and avoid scraping cables.
No idling downhill. In the process of no-load operation of the mixing truck, the mixing drum shall not stop rotating so as not to bump against the raceway and supporting wheel, resulting in abnormal damage to the supporting wheel and the raceway. Get used to testing your brakes before driving long or downhill. It is forbidden to slide down the slope of the mixing truck in neutral gear, and the low-grade engine is used to slow down. There will be a curve in the downhill section. When turning, decelerate in advance and then reduce gear and then decelerate, and the braking effect is good.
The above is about the small concrete mixer when driving to slow down the related content of the problem, if the mixer driver friends have questions please contact us or visit our home page http://www.zkzdsljbc.com!