Due to the requirements of energy conservation and emission reduction and the pressure of environmental protection, the future automatic mixer will be developed in the direction of high skill, high power, serialization and environmental protection. How do you operate the more widely used equipment to ensure safety? The following section explains it for you.
1. The fully automatic mixer must be slow when turning.
Full automatic mixer has a high center of gravity and is easy to roll over! Slow down and downshift early before turning, and try not to brake when turning. Check whether the jar is rotating through the rear-view mirror at any time, and adjust the speed as slowly as possible. If the speed is too high, the vehicle simply swings. This is the correct way to start the automatic concrete mixer. Stop the tank at the road section with large skew angle. When you come to the road section with large skew point when you are fully loaded with materials, stop the tank first. The center of gravity of the fully automatic mixer is high, so stopping the rolling of the tank body is conducive to maintaining the stability of the vehicle.
2. The fully automatic mixer truck downshifts early when going uphill.
If you pull it full, pay attention to the steep start, and pay more attention to the uphill. Don't downshift randomly, and downshift early. The rotation speed of the grout is accelerated to prevent concrete from flowing out.
3. The fully automatic mixer truck shall pass through the bad road at a suitable low gear.
In case of uneven road surface and potholes, use a suitable low-speed gear to pass by, so as to ensure that the car is explosive at any time. Planks and sharp stones must be avoided, especially heavy vehicles!
4. Full automatic mixer must pay attention to the height limit.
The road conditions on the construction site are messy, so be careful of trees, especially to avoid scraping wires.
5. The fully automatic mixer truck shall not slide down the slope with heavy truck in neutral gear.
You may have to get used to testing your brakes before going downhill for a long time. Do not slide downhill with heavy vehicles in neutral gear. When going downhill and turning, slow down early, then reduce gear, and then slow down. Brake in gear.
How to operate the fully automatic mixer safely? The above five points are explained, and I hope to give you good help. More relevant matters will come to our website http://www.zkzdsljbc.com Consult!