In general, if strong acid and strong alkali are used to corrode, the car tank may be damaged, and the cost is high, requiring a lot of acid and alkali. Now there is a special cleaning industry, with a cost of about 5000. It needs to be hit with an air cannon. One person should go in and clean up the solidified concrete. Therefore, we should pay attention to the cleaning after use and the shutdown time control during use. The more timely the concrete mixing tank is stopped, the easier it is to clean up the concrete.
另外需要注意的是，遇到这种情况，车损险是不予赔付的。按照车险规定：因自身运载货物或则车内物体运动碰撞导致本车车损，属责任免除范围。根据保险的近因原则，导致罐体损失的直接原因罐体停转、水泥凝固，而非意外事故导致罐体损失，所以是不予赔付的 。
In addition, it should be noted that in this case, the vehicle damage insurance will not be compensated. According to the provisions of vehicle insurance: the damage of the vehicle caused by the movement and collision of its own goods or objects in the vehicle belongs to the scope of liability exemption. According to the principle of proximate cause of insurance, the direct cause of tank loss is tank shutdown and cement solidification, rather than tank loss caused by accident, so it is not compensated.
也就是说如果遭遇罐体停转而混凝土凝固所受损失，是无法要求保险公司赔付的。
In other words, if the tank stops and the concrete solidifies, the insurance company cannot be required to compensate.
混凝土搅拌车在作业过程中如果液压系统发生故障，而刚好附近也没有可以使用的高压油管及救急的搅拌车，那么时间一长搅拌筒里的混凝土就会凝固在罐体内，一但混凝土凝固那么罐体基本上就算报废了。
If the hydraulic system of the concrete mixer fails during operation, and there is no high-pressure oil pipe and emergency mixer nearby, the concrete in the mixing drum will solidify in the tank over time. Once the concrete solidifies, the tank will basically be scrapped.
那么是否没有一点回旋的余地呢，世事无。当混凝土搅拌车遇上这种特殊情况时，如果不想更换罐体，可以请的清理人员对罐体进行破拆作业，其方法是将罐体用氧焊切割一个可供一个进入的大洞，然后用破拆机械，一点点进行破拆，人员进入罐体内一点点的进行破拆，直到混凝土清理干净。把罐体切割口用电焊封闭。
So is there no room for maneuver? There is no absolute in the world. When the concrete mixer meets this special situation, if you don't want to replace the tank, you can ask professional cleaning personnel to break and dismantle the tank. The method is to cut a large hole for one access with oxygen welding, then use the breaking and dismantling machinery to break and dismantle it bit by bit, and finally enter the tank to break and dismantle it bit by bit until the concrete is cleaned. Finally, seal the cutting opening of the tank body with electric welding.
Thank you for reading. Source of this article: automatic concrete mixer. For more contents and questions, please click: http://www.zkzdsljbc.com We will continue to work hard to provide you with services. Thank you for your support!
