Turn slowly. The mixer truck has a high center of gravity and is easy to roll over! Decelerate and downshift in advance before turning, and try not to step on the brake when turning. Observe whether the tank is rotating through the rearview mirror at any time, and slow down the speed as much as possible. If the speed is too high, the vehicle is easy to swing; Reverse slowly. Don't always stick your head out of the window. Look at the rear-view mirrors on both sides. If you're really uncertain, stop and look clearly before falling down. Many roads are just paved by excavators, which are relatively soft, and the car is easy to sink.
Low gear over "rotten road"
In case of uneven road surface and potholes, use appropriate low-speed gear to ensure that the car has explosive power at any time. Boards and sharp stones must be avoided, especially heavy cars!
Upslope advance downshift
If it's full, pay attention to a gentle start and pay more attention when going uphill. You can't downshift randomly. It's best to downshift in advance. Moreover, it is best to speed up the speed of the pouring to prevent the concrete from flowing out.
Do not slide the heavy vehicle in neutral gear downhill
Be used to testing the brakes before driving for a long time or going downhill. Do not slide down the slope with the loaded vehicle in neutral. When turning down the slope, slow down in advance, then reduce the gear, and then slow down. The braking effect with gear is the best.
Pay attention to the height limit
Whether the road conditions on the construction site are complex or during transportation, be careful of trees, wires, etc., especially to prevent scraping wires.
Get out of the car and check the reversing line
At the construction site, get off at night and check the reversing route with a flashlight. Where there are obstacles, pits or soft places, write them down one by one, and clean up in time in case of reinforcement nails and the like.
Preparation before unloading
Allow the concrete to be fully mixed. If necessary, add some water to make the concrete mix more evenly and facilitate unloading; When discharging, park the truck on the flat ground as far as possible. Wet the chute of the discharge hopper before discharging to facilitate cleaning.
Don't be careless when unloading
It's best to watch by yourself when discharging, so as to avoid the discharging operator's random operation of the discharging operating rod. It's best to stop every time the tank is reversing the middle position to protect the reducer, supporting wheel, etc.
Clean the mixing tank
When washing the tank, be sure to wash it carefully, and repeat the positive and negative rotation of the water twice, and then release it. In the last trip, put all the water in the water tank into the tank, and then return to the station to add water to clean the tank thoroughly.
Good products make good services, and good manufacturers make good works. Concrete mixers insist on providing customers with high-quality services. Please continue to pay attention to our website for details: http://www.zkzdsljbc.com