您好,欢迎光临莱州聚峰机械有限公司官方网站!

服务热线

400-879-1999

你所在位置: 首页 >> 混凝土搅拌车资讯 > 常见问题 >
常见问题

自上料混凝土搅拌车传动油质量检测方法有哪些?

来源:http://www.zkzdsljbc.com/ 时间:2020-11-23

1.将自上料混凝土搅拌车停在水平表面上并拧紧手刹。
Park the self loading concrete mixer on a horizontal surface and tighten the handbrake.

2、让发动机怠速作业几分钟。
Let the engine idle for a few minutes.

3、踩下制动踏板,将操纵杆转至倒档,前进档等,并在每个档上停留几秒钟,以向变矩器和所有换档执行器注满液压油,终将操纵杆转到停车方位。
Press the brake pedal, turn the lever to reverse, forward, etc., and stay in each gear for a few seconds to fill the torque converter and all shift actuators with hydraulic oil, and finally turn the control lever to the parking position.

4、从加油管上取下自动变速箱油尺,将清洁过的油尺插入加油管,然后将其拉出以检查油尺上的油位。
Remove the automatic transmission dipstick from the filler tube, insert the cleaned dipstick into the filler tube and pull it out to check the oil level on the dipstick.
混凝土搅拌车
5.在检查自上料混凝土搅拌车或对其进行缺点排除之前,请先检查变速箱油位和油质。将变速杆置于P方位,在空转时作业发动机至少几分钟,油液抵达正常的作业温度,并且车辆有停放在水平表面上,以确保差速器和油门之间的油位。传输通常是安稳的。

Please check the oil level and oil quality of the gearbox before checking or eliminating the shortcomings of the self loading concrete mixer. Place the shift lever in the P position, operate the engine at idle for at least a few minutes, the oil reaches the normal operating temperature, and the vehicle is parked on a horizontal surface to ensure the oil level between the differential and the throttle. Transmission is usually secure.
上一篇:小型搅拌机添加在工程使用的特点
下一篇:为保证全自动混凝土搅拌车的驱动装置完好可靠应如何维护
tag:混凝土搅拌车,小型混凝土搅拌车,全自动混凝土搅拌车

自上料混凝土搅拌车传动油质量检测方法有哪些?

作者:中科聚峰混凝土搅拌车厂家 时间:2020-11-23

1.将自上料混凝土搅拌车停在水平表面上并拧紧手刹。
Park the self loading concrete mixer on a horizontal surface and tighten the handbrake.

2、让发动机怠速作业几分钟。
Let the engine idle for a few minutes.

3、踩下制动踏板,将操纵杆转至倒档,前进档等,并在每个档上停留几秒钟,以向变矩器和所有换档执行器注满液压油,终将操纵杆转到停车方位。
Press the brake pedal, turn the lever to reverse, forward, etc., and stay in each gear for a few seconds to fill the torque converter and all shift actuators with hydraulic oil, and finally turn the control lever to the parking position.

4、从加油管上取下自动变速箱油尺,将清洁过的油尺插入加油管,然后将其拉出以检查油尺上的油位。
Remove the automatic transmission dipstick from the filler tube, insert the cleaned dipstick into the filler tube and pull it out to check the oil level on the dipstick.
混凝土搅拌车
5.在检查自上料混凝土搅拌车或对其进行缺点排除之前,请先检查变速箱油位和油质。将变速杆置于P方位,在空转时作业发动机至少几分钟,油液抵达正常的作业温度,并且车辆有停放在水平表面上,以确保差速器和油门之间的油位。传输通常是安稳的。

Please check the oil level and oil quality of the gearbox before checking or eliminating the shortcomings of the self loading concrete mixer. Place the shift lever in the P position, operate the engine at idle for at least a few minutes, the oil reaches the normal operating temperature, and the vehicle is parked on a horizontal surface to ensure the oil level between the differential and the throttle. Transmission is usually secure.

截屏,微信识别二维码

微信号:ZKJF6688

点击微信号复制,添加好友

 打开微信