1. Downhill braking
The purpose is to prevent the front of the car from sinking too much, increase the load of the tail wheel actively, and avoid the pressure on the bar.
2. Use the force between the toe and the sole of the foot to apply the brake
It is better to use the sole of the foot to brake quickly with the toe. It can step the whole brake pedal to the bottom in an instant, and give full play to the braking capacity. From the way a person usually operates the brake, you can see the level of driving. It is not the proper performance of a good driver to stop the car immediately or not to stop when it is time to stop.
3. Passenger braking depends on stability
When there are passengers in the back seat, the load on the front and rear of the car is relatively average. However, due to the increase of the weight of the passenger and vehicle, the inertia also increases, and the braking force required is greatly increased. When the brake is applied, the rear seat passengers may bump into the chair because they are unprepared, which makes the car unstable. Just teach the rear seat passengers how to sit.
4. How to use the throttle skillfully
In addition to the foot brake, we should also make good use of the accelerator to control the speed. In the case of a safe distance, once you need to slow down, as long as you release the throttle, properly cooperate with the foot brake, it is easier to control the speed. These are the skills of stepping on the brake. Car owners can learn according to their own needs. To know a good driving method is not only the performance of loving the car, but also the way to be responsible for their own safety.
5. When the speed is slightly slow, lean the car body to turn
Adjust the vehicle speed before turning: brake, shift and pump oil; in case of emergency, if there are obstacles, stop tilting immediately, straighten the body bar, and then brake.
The above is the automatic loading concrete mixer brake skills, I hope to bring you help.
Now our country attaches great importance to environmental protection, so we should actively respond to the national policy and start from the small things around us. In fact, the correct driving of automatic loading concrete mixer truck also contributes to environmental protection.
1. Pay attention to timing when parking and flameout
Especially for the engine of the automatic loading concrete mixer equipped with a turbocharger, if the engine is running at high speed, when you stop the car, if the engine turns off quickly, it will produce more carbon deposition. Therefore, we should let the engine idle for a period of time, generally about 5 minutes, so that no more carbon deposition will be produced, It also helps to maintain the engine of our car.
2. Choose clean gasoline and diesel
Impurities in gasoline and diesel oil are the main cause of carbon deposition, because when gasoline and diesel are burned in the combustion chamber, if there are impurities, it will cause incomplete combustion, and it is easy to produce a lot of carbon deposition. In addition, the waste inside the impurities will also pollute the cylinder block of the combustion chamber.
3. Don't idle for a long time
As we all know, the longer the idle time is, the longer it takes for the engine to reach normal temperature. After gasoline is injected into the back of the valve, the evaporation rate is slow, and carbon deposition is also generated. At the same time, often idling, the air flow into the engine is also small, so the scouring effect on carbon deposition becomes very weak, which will promote the deposition of carbon. At this point, there will be more insufficient combustion in the combustion chamber.
This article is organized and released by the automatic concrete mixer truck. Do you have any understanding of these contents? For more information, please click: http://www.zkzdsljbc.com We'll have a lot more to see.