During the loading and transportation process of the fully automatic mixer, you must pay attention to safety when you operate, and do not make relevant mistakes. Of course, you should be careful in all aspects. Now let's talk about how to decorate and transport safely.
The mixing drum shall be reversed before loading. During the first shift operation, the vehicle shall be reversed as far as possible. Because most vehicles are parked in the open air, there may be water, leaves and other debris in the tank. If it is not discharged, the concrete quality will be affected.
After loading, remember to wash the feed hopper, otherwise the small stones scattered during loading will easily solidify inside and outside the receiving hopper and on the chute, affecting the use and beauty.
When turning, you must be slow. The mixer truck has a high center of gravity and is easy to roll over! Slow down and downshift in advance before turning, and try not to brake when turning. Observe whether the tank is rotating through the rearview mirror at any time, and adjust the speed as slowly as possible. If the speed is too high, the vehicle is easy to swing.
If the road surface is not good, use a low gear to pass through uneven and potholed areas, so as to ensure that the car has sufficient power. Avoid big pits, stones, steel bars and iron blocks, especially heavy vehicles.
When going uphill, you should downshift ahead of time. If you pull full, you should start slowly. When going uphill, you should pay more attention. You should not downshift randomly, so you can downshift ahead of time. At the same time, it is good to speed up the rotation speed of the tank to prevent concrete from flowing out.
Do not coast with heavy vehicles in neutral gear when going downhill. Drive in proper gear for a long time or before going downhill. Do not slide downhill with loaded vehicles in neutral gear. When going downhill and turning, decelerate in advance, then downshift and decelerate again. The effect of braking in gear is good.
Attention must be paid to the problem of height limit. The road conditions on the construction site are complex, so be careful of trees, especially to prevent scraping the wires.
The correct operation of the fully automatic mixer during loading and transportation will be explained here. For the sake of personnel safety and equipment integrity, you should learn more and remember the precautions. Follow us http://www.zkzdsljbc.com Learn more!